Forum Post: RE: Sitara AM3359 EtherCAT not working with Renesas UPD60621 PHYs
Frank,I just saw that your working in Freising, will you join the TI MCU Design Days next week? I'll be there on both days!Have a nice weekend!RegardsJens
View ArticleForum Post: RE: Ethernet switch and gigabit phy connection to AM335x
Ultimate suitability for a particular peripheral device, in this case the Marvell switch, is the responsibility of the customer as we can't claim expertise in another vendor's part. I have not seen the...
View ArticleForum Post: RE: Am335x UART0 and serial console
[quote user="Biser Gatchev-XID"]Yes, it should be in the device tree if you are using SDK 7.0.[/quote]We do not have SDK 7.0. How can we change it? Thanks.
View ArticleForum Post: RE: What is the max. NAND capacity accepted by the AM335x GPMC...
Thank you Biser.Regards.
View ArticleForum Post: DCAN interface not working on Beagle Bone Black
Hi All,I have enabled both DCAN0 and DCAN1 interfaces on BBB. I am using the canutils for testing the CAN interface, I am trying to transmit on CAN0 (./cansend can0 5AA#) and receive on CAN1 (candump...
View ArticleForum Post: RE: AM437x HDMI Audio Playback
If you use the Linux version that is part of our EVM, does it work?
View ArticleClik here to view.
Forum Post: RE: Changing from AM335 720MHz to 1GHz
Well, i checked the supplies and compared between the 720MHz and 1GHz boards, but there didn't seem to be much difference. It also didn't seem like there was much noise or spikes on either : /.I am...
View ArticleForum Post: RE: Can we disable the RTC node in the AM335x tree somehow?
[quote user="Dave Gerlach"]In order to disable the RTC you must mark the node as disabled in the dts file[/quote]Dave, are you talking just about this line:status = "disabled";or this line...
View ArticleForum Post: Android ON Am1808 EVM kit
Hello,I have AM1808 EVM kit. I am trying to port android froyo on my kit.I am following the steps described in ,http://processors.wiki.ti.com/index.php/TI-AM1808-Android-FroYo-DevKit_UserGuideI started...
View ArticleForum Post: What is the maximum speed of GPMC with AM3352
While I used the AM3352 communicated to FPGA, use DMA GPMC with burst mode. But the maximum speed only 12MB. The configuration of GPMC as follows:#define FCLKDIV 2#define READ_ACC_CLCLE 5#define...
View ArticleForum Post: Analog pins as open drain outputs
Hi,According to AM335x Sitara™ Processors data sheet, AIN3 and AIN4 can be configured as an open-drain outputs. How can I do it? How can I control output?Thanks in advance for response!Dragan
View ArticleForum Post: RE: AM335X with Wifi Module WL18xx
Hello Biser,I missed one query regarding Wifi Module WL18xx.As mentioned earlier,We need to stream online video (Full HD 1080p) over Wifi using Module WL18xx (as mentioned in link :- data transfer rate...
View ArticleForum Post: LCD_BACKLIGHTEN pin function starter kit
Hello,We are going to use the AM335x starter kit as a refernce design for our project.down loading the pinmux from TI web, refer that the signal "LCD_BACKLIGHTEN" output pin C12 from the CPU,declared...
View ArticleForum Post: RE: AM437x PRU failed download
hiyes i have.could you tell me the problem is caused by drive or download application....please give me some advices.li
View ArticleForum Post: RE: AM335x EtherCAT Known Issues LWR commands
HiOur customer has been considering Sitara to build EtherCAT network.They have concerned that limitations to master side might be occured due to SDOCM00092510 that is known issues and limitations of...
View ArticleForum Post: RE: AM335X with Wifi Module WL18xx
You need to post this question in Wifi forum...we reply questions related to our processors...Wifi module comes from a different group.
View ArticleForum Post: AM3352 DDR3 Issue
Hello,We are using 512MB DDR3 part from ISSI, IS43TR16256A-125KBLI. While DDR testing, we tried to write some data on the first two locations as shown below,0x80000000 wr data...
View ArticleForum Post: RE: AM3358 DDR3 Software Levelling
Thanks for your help Biser. I've got it working now. I had used the AM335x_EVM_DDR2_LE.reg file as a starting point but had not set up the PLLs correctly and had incorrect and missing values in my .reg...
View ArticleForum Post: Cache and store buffer maintenance in cortex-a8!
Dear All,Technical data sheets for the ARM7500FE and ARM7100 say that:"In the ARM Processor the cache will be searched regardless of the state of the C bit, only reads that miss the cache will be...
View Article