Forum Post: RE: AM335x without 32khz xtal
One more quick experiment. In arch/arm/mach-omap2/omap_hwmod_33xx_data.c can you comment out&am33xx_rtc_hwmod,This is just a quick test.Steve K.
View ArticleForum Post: RE: I2C on the TMDXEVM3358 - AM335x Evaluation Module
Hi,You can use expansion connectors to connect your device to one of the I2C ports. The description of these connectors are shown here:...
View ArticleForum Post: RE: [Boot AM335x-evm Rev 1.2 A] Does anyone happen to boot this...
Thanks for updating the thread.
View ArticleForum Post: RE: AM335x : IPU/IPD configuration for unused Pins
Hi Biser,Thank you for the reply.I understood.My customer are asking me about configuration of IPU/IPD for DDR3 unused pin(DQS/DQSn).They will PU/PD the DQS1/0 and DQSn1/0 externally, so that I will...
View ArticleForum Post: RE: Booting Linux on AM3359 ICE
My congratulations, Dennis!Iceboard boot from SD.. Your have login prompt?Next step - add rtc chip for backup time and date - may be ds1340 (or similar to i2c bus) and coin LioN battery (cr2032 or...
View ArticleForum Post: RE: TAM-3517 Technexion source code android 4.1.2
Hi Virginie, This question should be asked in the Android forum: http://e2e.ti.com/support/embedded/android/default.aspx. However I believe you should contact the module manufacturer, if they are...
View ArticleForum Post: RE: No division instructions with AM335x
Hi Andreas, Quoting from another post: "....If you look at section B4.1.83, you can find the Instruction Set Attribute Register 0, VMSA. Divide_instrs, bits[27:24] indicates the implemented Divide...
View ArticleForum Post: RE: AM335x Starter Kit DDR3 at 400MHz
Hi Matteo, There is no reason why the DDR3 should not run at 400MHz on the SK. You may need to retune the settings though. The procedure is described...
View ArticleForum Post: RE: About GPMC configration register setting
That's not it then, I was suspecting that your short timings get masked by the wait signal somehow, but that isn't the case. Is there a way you can see what's happening on the nADV signal?
View ArticleForum Post: RE: ddr3
Hi,Please see this post and let me know if it helps: http://e2e.ti.com/support/arm/sitara_arm/f/791/p/269821/944406.aspx#944406Best regards,Miroslav
View ArticleForum Post: RE: AM335x NAND Flash Tool or nandlib does not support BCH 16-bit...
Hi,There are three *patch series* which you need to pick to get BCH16 working:(1) http://lists.infradead.org/pipermail/linux-mtd/2013-October/049410.htmlThere are 10 patches in this series (status:...
View ArticleForum Post: RE: AM335x UART fails into frame error, break condition in FIFO...
Yes, followed instructions in TRM that you just mentioned.
View ArticleForum Post: RE: AM335x - clarification of OPP50 and EMAC/CPSW usage on for...
Hi Anthony, Yes, the AM3352BZCZD30 is specified to run at the voltage level defined for OPP100 and at a frequency of 300 Mhz. Check note (3) below the table.
View ArticleForum Post: RE: AM335x: ADC problem (Kernel-3.2.0-psp04.06.00.11)
I've found out what was going on.With the BeagleBone, I was able to get everything working. I then compared arch/arm/configs/am335x_evm_defconfig with my configuration file and turns out this options...
View ArticleForum Post: AM3358 vs AM3352
Hi All,I am in the process of bring up Linux 3.2 on my AM3352 based board. I based the design on the EVM kit, which has an AM3358. I have been chasing a kernel oops before the console is up. I have...
View ArticleForum Post: RE: What settings are needed for OMAPL138 LCDK to run the example...
Hi,In order to make problem simpler, I set bypass to C674x_0, PRU_0, PRU_1 in target configuration. It goes longer in downloading.This is a simple hello.c application:#include <stdio.h>/* *...
View ArticleForum Post: RE: RTC Current Consumption - Revision 2 Silicon
DId anyone ever determine typical RTC power consumption for this series processor? Thanks.
View ArticleForum Post: RE: AM335x - clarification of OPP50 and EMAC/CPSW usage on for...
The comment "Operation of the Ethernet MAC and switch is not supported for OPP50" on page 118 of the data sheet, is a restriction imposed when VDD_CORE OPP is configured for OPP50. See Table 3-6.This...
View ArticleForum Post: RE: About a sequence of McASP operation in Am335x
Hi BiserThenk you for reply Comment.We recognize the existence of the initialization procedure of regular, but because Mute function was realized by it in the evaluation board operation to (XFMT =...
View ArticleForum Post: RE: AM335X synchronous BURST WRITE ,Non-Multiplex
Biser, Thanks a lot,! Can anybody else help me?
View Article