Forum Post: RE: am335x sd card can not boot
If I remember correctly, the Beagebones do not use the CD pin and they work fine.You probably have to change your kernel. If you are using a 3.2 kernel, you modify arch/arm/mach-omap2/board-am335xevm.c...
View ArticleForum Post: RE: AM3359ZCZ - UBOOT
The logic states applied to SYSBOOT inputs are only latched on the rising edge of PWRONRSTn, so the SYSBOOT register value should not change as a result of warm reset.Regards,Paul
View ArticleForum Post: RE: u-boot compilation does not show commands
In fact the SDK VERSION 06.00.00.00 causes an environment error that I do not identified when I run setup.sh. Preview version is ok.Solution: fix cross-compile path in a .source file or .bashrc; load...
View ArticleForum Post: RE: AM335X 10MB/s ethernet issues
Hi Steve,The mii1_col and mii1_csr pins were indeed not explicitly muxed, and adding them to the dts file as inputs made no difference (which would e expected as we are running in full-duplex where...
View ArticleForum Post: RE: AM3352 4-wire touchscreen
Why do you need to change the clk to kHz range? I assume you need to do this to decrease the ADC sample rate.My reply below is from the hardware perspective. I cannot comment how this is done in...
View ArticleForum Post: RE: AM335x WARMRSTn not used
Thank you Biser, I understood.Regads,Takeshi Matsuzaki
View ArticleForum Post: RE: USB certification for AM335x
AM335x has not been certified by USB-IF.We took an AM335x EVM to a USB_IF workshop several years ago with plans to get the silicon certified. While preparing to attend the workshop, USB-IF ask a few...
View ArticleForum Post: RE: PRU external memory interface
No, you need not.The L3 interconnect logic handles this for you.
View ArticleForum Post: RE: A bizarre jump with AM3358
Is this bare metal code? Where do you call it from?
View ArticleForum Post: RE: VFS: Cannot open root device "mmcblk0p2" or...
Angsrom build v3.8 is not supported on this forum. For support on BBB and Angstrom please turn to the community at: http://beagleboard.org/Community/Forums
View ArticleForum Post: RE: how to make uboot-2013.01-psp06.00.00.00(in sdk6.0) to...
I will forward this to the Linux experts.
View ArticleForum Post: RE: kernel and i2c write command
Hi Daniel,I will forward this to the Linux experts.
View ArticleForum Post: RE: How to set fw_env.config
Hi BiserI very appreciate your quickly reply.BestRegardsBernie
View ArticleForum Post: RE: Custom our board based on AM335x starter kit
Hi: Does AM335x limit the standard of eMMC ?? Or depend on which standard type of eMMC itself and the module mmc of AM335x could support all of them.
View ArticleForum Post: RE: NDK/NSP for AM3359 ICE v1
Timo, The newer version of Industrial SDK (1.1.0.5) is out and is compatible with NDK 2.24.0.11. In case if you need to use the latest NDK you can migrate to the ISDK 1.1.0.5 version...
View ArticleForum Post: RE: I2C "bus monitor" Application Question
Looking at the I2C registers I don't see any way that ACK/NAK can be blocked.
View ArticleForum Post: RE: AM3352 18bit RGB LCD
We are using the same cable with the customer board and found no issues.
View Article