[quote user="Mike Worster"]2) I found my profile selection switch (SW8) and the pins (1, 2, 3, 4) are all in the "off" position. I assume this is profile #0. Can you confirm? Then would I adjust the positions as I showed below for the new profiles?:[/quote]
The hardware user's guide states that "the fourth DIP switch is reserved and should always be OFF." The table should be as follows:
| Pin #1 | OFF | ON | OFF | ON | OFF | ON | OFF | ON |
| Pin #2 | OFF | OFF | ON | ON | OFF | OFF | ON | ON |
| Pin #3 | OFF | OFF | OFF | OFF | ON | ON | ON | ON |
| Profile | 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7 |