Forum Post: Powering AM3352 using TPS65910A3

Hi,

I am planning to use TPS65910A3 for powering AM3352. TI general purpose EVM and application note SWCU093C mentions the boot modes to be 10 (Boot1 = 1 and boot0 = 0). The PMIC datasheet doesn't provides the sequencing diagram for this specific setting under section 'SWITCH-ON/-OFF SEQUENCES AND TIMING'. Are there any specific care abouts for powering AM3352 using this device or i can just make the boot mode as 10 and it will automatically take care of powering sequence ?

Thanks & Regards,

Nikhil