Hi Sir :
I works on AM3359 EVM platform and use SDK 6.00.00.00.
The file system I use is arago-base-tisdk-image-am335x-evm.tar.gz.
And my boot log is as below.
[ 1.373748] Trying to load am335x-pm-firmware.bin (60 secs timeout)
[ 1.373901] Copied the M3 firmware to UMEM
[ 1.374206] smartreflex smartreflex: am33xx_sr_probe: Zero NValue read from EFUSE
[ 1.374237] smartreflex: probe of smartreflex failed with error -22
[ 1.374420] Cortex M3 Firmware Version = 0x181
[ 1.374786] sr_init: platform driver register failed
[ 1.380676] clock: disabling unused clocks to save power
[ 1.401367] Detected MACID=d4:94:a1:8f:73:68
[ 1.403045] cpsw: Detected MACID = d4:94:a1:8f:73:69
[ 1.405456] omap_rtc am33xx-rtc: setting system clock to 2000-01-01 00:00:00 UTC (946684800)
[ 1.479644] kjournald starting. Commit interval 5 seconds
[ 1.488769] EXT3-fs (mmcblk0p2): using internal journal
[ 1.488800] EXT3-fs (mmcblk0p2): mounted filesystem with ordered data mode
[ 1.488861] VFS: Mounted root (ext3 filesystem) on device 179:2.
[ 1.489257] Freeing init memory: 236K
INIT: version 2.88 booting
Error opening /dev/fb0: No such device
Starting udev
Ending udev
Starting Bootlog daemon: bootlogd: cannot allocate pseudo tty: No such file or directory
bootlogd.
Configuring network interfaces... udhcpc (v1.20.2) started
Sending discover...
Sending discover...
Sending discover...
Sending select for 172.16.196.131...
Lease of 172.16.196.131 obtained, lease time 345600
/etc/udhcpc.d/50default: Adding DNS 172.16.176.200
/etc/udhcpc.d/50default: Adding DNS 172.16.0.1
/etc/udhcpc.d/50default: Adding DNS 172.16.0.2
done.
Tue Jun 25 23:08:00 UTC 2013
[ 10.753417] net eth0: CPSW phy found : id is : 0x7c0f1
[ 16.744659] PHY: 0:00 - Link is Up - 100/Full
INIT: Entering runlevel: 5
Starting system message bus: dbus.
Starting telnet daemon.
Starting syslogd/klogd: done
Starting thttpd.
Stopping Bootlog daemon: bootlogd.
My questions are as below.
1.How to let time code disappear?
2.I found out that if I remove udev script, the system will hang up, why ?
3.Since I do not use fb, how could I eliminate error message "Error opening /dev/fb0: No such device" ?
4.How could I eliminate error message "Starting Bootlog daemon: bootlogd: cannot allocate pseudo tty: No such file or directory bootlogd." ?
5. The Ethernet configuration is too slow, it takes a lot time, is there any way to speed up Ethernet init?
PS: I only want to enable eth0.
Please help me!
Best regard,
Marcus
